Toyama Ryu Standard Cuts - Migi Kesa 右袈裟

Falling diagonal cut to the right

Start in Seagon Kamae
- Switch the forward foot
- Step up with the left foot and back with the right foot
- Maintain position
Announce the name of the cut “MIGI KESA” and raise the sword to the starting position.
- Movement should start with kissaki
- Reach out with kissaki as katana is raised overhead
- Do not change stance
Starting Position of cut
- Katana monouchi should be at about 10 degrees up. It has to be between horizontal and 45 degrees.
- Katana should be at least 6 inches above the head
- Koshira should be about 4 inches in-front of the forehead
- Koshira should be just within peripheral vision when looking forward
- Elbows should be pushed out to keep from obscuring view
- Bones in forearms should be aligned with tsuka
- Wrists should be pushed inward to “wring” the tsuka
- Keep the shoulders down and even
Making the cut
- The left hand should never move the right or left
- Start the cut with the hand moving forward (not down)
- The left hand should rotate and the right hand push up to snap the kissaki up
- Reach out with kissaki to a point as far forward as possible 6” to the left of the left foot and one feet over the head
- The kissaki should pass directly in-front at about the chest level
- The edge should be angled slightly farther down than the direction of the cut
- Stop putting energy into the cut after reaching this point
- Do not allow pad of hand to slip off the tsuka
- Let the arms relax and let the sword drop into the final position of the cut
- The kissaki should not bounce
- Do not drop the body
Finishing position of cut
- Make sure the pads of hands are still on top off the tsuka
- The right arm should be bent with the elbows at the sides
- The kissaki should be forward and level with the knee and about 6” to the right of the right foot.
- The edge should be still be angled slightly farther down than the direction of the cut
- The shoulders should be down and even
- The left hand should be directly in-front of the navel
Moving back to starting position for the next cut
- Movement should start with kissaki
- Reach out with kissaki as katana is raised overhead
- Move the kissaki in a straight arc
- Do not change stance
Moving back to Seagon Kamae after all cuts
- Lead the movement with the kissaki
- Move the kissaki to the center rising up at about a 45 degree angle and returning the ha to a vertical position
- Continue to raise the kissaki to throat level after reaching the center

Samurai Swords   Iaito (Practice Swords)   Shinken (Cutting Swords)
Wakizashi (Short Swords)   Tanto (Daggers)   Japanese Weapons   Maintenance
Uniforms   Sharpening   Sword Repair   Sword Customization Tatami Targets